Today I would like to share a pop-up card for a friend.
To decorate the card I used a small square from Spellbinders S4-1047 - Richelieu Squae. I also added a tiny tag and stamp from Spellbinders SDS-053 - Graceful Tiny Tags. I handmade flowers using Spellbinders S4-982 - Cinch and Go Flowers IV.
Inside the card I added a pop-up mechanism from Spellbinders S4-1032 - 3D Interactive Pivot Banner. I added a decorative swirl from Spellbinders S4-926 - Swirl Tags.
Since my card is small. It measures 9cm x 9cm only I adjusted slightly the pop-up mechanism. I trimmed both sides so it is now approximately 1''-5/8' wide.
I adhered it inside the card as normal. You can check Becca Feeken's tutorial where she shows two ways of using it ---> click.
I cut my four piece and trimmed it to have four squares 1''-5/8' x 1''-5/8'. I just wanted the pop-up to be squares like the card.
If I would not trim the panel a bit on both sides it would be visible here from under the four-square panel.
When I have finished my card I decided to add a bow closure.
Thank you so much for stopping by.
Dziekuje bardzo za odwiedziny.